Testing, reliability & durability

ISO 12405-3:2014 specifies test procedures and provides acceptable safety requirements for voltage class B lithium-ion battery packs and systems, to be used as traction batteries in electrically propelled road vehicles. Traction battery packs and systems used for two-wheel or three-wheel vehicles are not covered by ISO 12405-3:2014. ISO 12405-3:2014 is related to the testing of safety performance of battery packs and systems for their intended use in a vehicle.

Provides a number of methods, describing in each case the apparatus required, precautions required, procedure and interpretation of the results of proving gas tightness of vacuum or pressurized plant. Contains over 100pp.

Purpose of this Guidebook: This guidebook provides information on the requirements to achieve and renew a Compressed Natural Gas (CNG) Cylinder and Fuel System Inspector personnel certification.
About this Certification: The CNG Cylinder and Fuel System Inspector Certification was developed to meet the needs of fleets of all sizes that use safe, cleaner-burning natural gas to power their vehicles.

This standard shall apply to the design, installation, acceptance testing, operation, and ongoing periodic testing of smoke control systems. A.1.1 This standard incorporates methods for applying engineering calculations and reference models to provide a designer with the tools to develop smoke control system designs. The designs are based on select design objectives presented in Section 4.1.

Applies to telecontrol equipment and systems with coded bit serial data transmission for monitoring and controlling geographically widespread processes; specifies rules for structuring application data units in transmission frames of telecontrol systems.
This publication is of high relevance for Smart Grid.

IEC 60870-5-6:2006 Specifies methods for conformance testing of telecontrol equipment, amongst substation automation systems and telecontrol systems, including front-end functions of SCADA. Facilitates interoperability by providing a standard method of testing protocol implementations. Is expected to minimize the risk of non-interoperability.

IEC 60870-5-104:2006+A1:2016 Defines a telecontrol companion standard that enables interoperability among compatible telecontrol equipment. Applies to telecontrol equipment and systems with coded bit serial data transmission for monitoring and controlling geographically widespread processes.
This publication is of high relevance for Smart Grid. This consolidated version consists of the second edition (2006) and its amendment 1 (2012). Therefore, no need to order amendment in addition to this publication.

IEC TS 60870-5-601:2015(E) describes test cases for conformance testing of telecontrol equipment, Substation Automation Systems (SAS) and telecontrol systems, including front-end functions of SCADA. The use of this part of IEC 60870 facilitates interoperability by providing a standard method of testing protocol implementations, but it does not guarantee interoperability of devices. It is expected that using this part of IEC 60870 during testing will minimize the risk of non-interoperability.

IEC TS 60870-5-604:2016(E) RLV contains both the official IEC International Standard and its Redline version. The Redline version is not an official document, it is available in English only and provides you with a quick and easy way to compare all the changes between the official IEC Standard and its previous edition.

This document was prepared by BC Hydro (BCH) to guide generator owners and proponents in connecting generators to the BCH distribution system at 35 kV and below. It applies to all generators, whether utility or non-utility owned, and these generating plants are referred to as a Power Generator (PG).