Design

This guideline is primarily intended to provide an overview of the application process involved in becoming a distributed generator. If a prospective power plant owner plans to generate electric energy and the power plant capacity rating is less than one MW, the applicant may proceed without filing an application with the Alberta Utilities Commission (AUC) if the following three requirements are met: ? No person is directly and adversely affected. ? The power plant complies with AUC Rule 012: Noise Control (AUC Rule 012). ? There is no effect on the environment.

The scope of this document is to provide guidelines for consistant and standard applications for voltage and power quality requirements on or connected to HOL’s distribution system. Normally voltage limits, voltage distortion, and current distortion are measured at the customer’s Point of Supply as per HOL document ECS0012. This document does not cover the following power quality issues: • Voltage control when the Independent Electrical System Operator (IESO) has declared a voltage reduction or an electrical system emergency; • Non-standard conditions such as a force majeure (e.g.

This guideline is intended to assist the customer in understanding the connection process that results in connection of the customer's generation facility to Hydro Ottwwa's distribution network. This guideline does not provide all the details of costs or responsibilities that the customer may assume; such details will be evaluated for each specific request.

This publication provides information on the physical and chemical properties of hydrogen and proper handling and use. It is intended to provide background information for personnel involved in the manufacture, distribution, and use of hydrogen. Additional technical information can be obtained from hydrogen gas manufacturers.

This publication presents design guidelines for hydrogen vent systems used in gaseous and liquid hydrogen systems at user sites and provides recommendations for safe operation of these vents. It begins at the discharge port of safety devices and other components that control the release of hydrogen and ends at the point where hydrogen concentration in the atmosphere is below the lower flammable limits.

These requirements cover bidirectional electric vehicle charging equipment that charge electric vehicles from an electric power system and also include functionality to export power from the electric vehicle to an electric power system. When commanded, the bidirectional charging equipment exports electric power from the electric vehicle stored energy supply to the electric power system (EPS) to supply power to common loads.

This International Standard specifies requirements and tests for the safe operation of portable sealed secondary cells and batteries (other than button) containing alkaline or other non-acid electrolyte, under intended use and reasonably foreseeable misuse

IEC TR 61850-7-500:2017(E) describes the use of the information model for devices and functions of IEC 61850 in applications in substation automation systems, but it may also be used as informative input for the modeling of any other application domain. In particular, it describes the use of compatible logical node names and data objects names for communication between Intelligent Electronic Devices (IED) for use cases. This includes the relationship between Logical Nodes and Data Objects for the given use cases.

1.1 Scope This standard establishes nominal voltage ratings and operating tolerances for 60-hertz electric power systems above 100 volts. It also makes recommendations to other standardizing groups with respect to voltage ratings for equipment used on power systems and for utilization devices connected to such systems. This standard includes preferred voltage ratings up to and including 1200 kV maximum system voltage, as defined in the standard.

Third parties must use certified equipment (both behind the meter and on the distribution grid) when attempting to interconnect new components to the grid. Certified equipment is equipment that has passed through rigorous certification testing procedures done by Nationally Recognized Testing Laboratories (NRTLs); UL is one such example. NRTLs create testing procedures for equipment that verify equipment functionality and safety to pre-set testing standards created by nationally recognized engineering groups such as IEEE.