Testing, reliability & durability

This part of IEC 60896 applies to all stationary lead-acid cells and monobloc batteries of the valve regulated type for float charge applications, (i.e. permanently connected to a load and to a d.c. power supply), in a static location (i.e. not generally intended to be moved from place to place) and incorporated into stationary equipment or installed in battery rooms for use in telecom, uninterruptible power supply (UPS), utility switching, emergency power or similar applications.

Abstract: Part 2 sets out recommended practices for the installation, maintenance, testing and replacement of sealed secondary batteries permanently installed in buildings.
Scope:

1 Scope
1.1 These requirements apply to controls that employ solid-state devices and are intended for specified safety-related protective functions.

IEC 62282-3-100:2012 is applicable to stationary fuel cell power systems intended for indoor and outdoor commercial, industrial and residential use in non-hazardous (unclassified) areas. It contemplates all significant hazards, hazardous situations and events, with the exception of those associated with environmental compatibility (installation conditions), relevant to fuel cell power systems, when they are used as intended and under the conditions foreseen by the manufacturer.

ISO 13849-2:2012 specifies the procedures and conditions to be followed for the validation by analysis and testing of the specified safety functions, the category achieved, and the performance level achieved by the safety-related parts of a control system (SRP/CS) designed in accordance with ISO 13849-1.

This manual defines a series of tests to characterize aspects of the performance or life behavior of
batteries for plug-in hybrid electric vehicle (PHEV) applications. Tests are defined based on the
Vehicle Technologies Program targets for plug-in hybrid electric vehicles, though it is anticipated
these tests may be generally useful for testing energy storage devices for plug-in hybrid vehicles. The
test procedures in this manual are directly applicable to complete battery systems. However, most

IEC 62282-2:2012 provides the minimum requirements for safety and performance of fuel cell modules; it applies to fuel cell modules with or without an enclosure which can be operated at significant pressurization levels or close to ambient pressure. Deals with conditions that can yield hazards to persons and cause damage outside the fuel cell modules. This edition includes the following significant technical changes with respect to the previous edition:
- inclusion of definitions for hazards and hazardous locations based on the IEC 60079 series;

ISO 22734-1:2008 defines the construction, safety and performance requirements of packaged or factory matched hydrogen gas generation appliances, herein referred to as hydrogen generators, using electrochemical reactions to electrolyse water to produce hydrogen and oxygen gas.
It is applicable to hydrogen generators that use the following types of ion transport medium:
Group of aqueous bases;
Solid polymeric materials with acidic function group additions such as acid proton exchange membrane (PEM).

Preface
This is the eighteenth edition of CSA B51, Boiler, pressure vessel, and pressure piping code. It supersedes the previous editions published in 2009, 2003, 1997, 1995, 1991, 1986, 1981, 1975, 1972, 1969, 1965, 1960, 1957, 1955, 1951, 1945, and 1939.

ASME has been defining piping safety since 1922.
ASME B31.3 contains requirements for piping typically found in petroleum refineries; chemical, pharmaceutical, textile, paper, semiconductor, and cryogenic plants; and related processing plants and terminals. It covers materials and components, design, fabrication, assembly, erection, examination, inspection, and testing of piping.