Pertinent

1 Scope
1.1 These requirements cover battery chargers rated 600 volts or less. They are intended to be used in accordance with the National Electrical Code, NFPA 70, to charge industrial storage batteries which are used to provide power for material handling trucks, tractors, personnel carriers, and similar motive equipment. These chargers may be either cord and plug connected or permanently connected.

Guidance and implementation procedures for the IEEE 1680 family of standards is provided, and the methods by which manufacturers may declare electronic products as conforming with the standards in the IEEE 1680 family of standards and by which such conformance may be verified are defined. The standards within the family will provide clear and consistent performance criteria for the design of electronic products, thereby providing an opportunity to secure market recognition for efforts to reduce the environmental impact of electronic products.

Service conditions, electrical ratings, thermal ratings, and environmental testing requirements are defined for communications networking devices to be installed in electric power substations. This standard establishes a common reproducible basis for designing and evaluating communications networking devices and the communications ports of protective relays for use in this harsh environment.

1 Scope
This standard specifies the re-use of electrical and electronic products and components and parts evaluation, evaluation of recycled materials, recycling Enterprises Evaluation
Claim.
This standard applies to electrical and electronic products for waste reuse and recycling processes are involved in the business and product systems
Evaluation.
2 Normative references
The following documents contain provisions which, through reference in this standard and become the standard terms. For dated references, subsequent

IEC TR 62746-2:2015(EN) describes the main pillars of interoperability to assist different Technical Committees in defining their interfaces and messages covering the whole chain between a smart grid and smart home/building/industrial area.

IEC TR 61850-90-3:2016(E) addresses communication aspects related to specific sensor networks that are widely used as well as information exchange towards asset management systems. Since the outcome of this work will affect several parts of IEC 61850, in a first step, this technical report has been prepared to address the topic from an application specific viewpoint across all affected parts of IEC 61850. Once this technical report has been approved, the affected parts of the standard will be amended with the results from the report.

IEC 61131-6:2012 specifies requirements for programmable controllers (PLCs) and their associated peripherals, as defined in Part 1, which are intended to be used as the logic subsystem of an electrical/electronic/programmable electronic (E/E/PE) safety-related system. A programmable controller and its associated peripherals complying with the requirements of this part is considered suitable for use in an E/E/PE safety-related system and is identified as a functional safety programmable logic controller (FS-PLC). An FS-PLC is generally a hardware (HW) / software (SW) subsystem.

IEC 61850-5:2013 applies to power utility automation systems with the core part of substation automation systems (SAS); it standardizes the communication between intelligent electronic devices (IEDs) and defines the related system requirements to be supported. The major technical changes with regard to the previous edition are as follows:
- extension from substation automation systems to utility automation systems;
- inclusion of interfaces for communication between substations;
- requirements from communication beyond the boundary of the substation.

IEC/IEEE 61850-9-3:2016(E) specifies a precision time protocol (PTP) profile of IEC 61588:2009 / IEEE Std 1588-2008 applicable to power utility automation, which allows compliance with the highest synchronization classes of IEC 61850-5 and IEC 61869-9.

IEC/TR 61850-90-1:2010(E) provides a comprehensive overview on the different aspects that need to be considered while using IEC 61850 for information exchange between substations. In particular, this technical report defines use cases that:
- require an information exchange between substations;
- describes the communication requirements;
- gives guidelines for the communication services and communication architecture to be used;
- defines data as a prerequisite for interoperable applications;