Pertinent

The sizing of nickel-cadmium batteries used in standby operation for stationary applications is discussed in this recommended practice

This guide describes methods for selecting the appropriate type of valve-regulated, immobilized-electrolyte, recombinant lead-acid battery for any of a variety of stationary float applications. The purpose of this document is to ensure that the reader is aware of all significant issues that should be considered when selecting VRLA batteries, so that the user might make an informed decision

A method for properly sizing the PV array and battery for stand-alone PV systems where PV is the only charging source is recommended (in conjunction with IEEE Std 1013TM). Load calculations and determination of solar radiation in the sizing of the system need special attention. Additionally, the critical nature of the load in deciding an acceptable annual availability needs to be considered

 This standard guides manufacturers/suppliers in planning and implementing the controls for the design and manufacture of lithium-ion (Li-ion) and lithium-ion polymer (Li-ion polymer) rechargeable battery packs used for multi-cell mobile computing devices. The provisions of this standard work together to define approaches to design, test, and evaluate a cell, battery pack, and host device to mitigate battery system failure. Additionally, this standard provides recommendations for end-user education and communication materials.

Criteria for design analysis for qualification, quality, and reliability of rechargeable lithium ion and lithium ion polymer batteries for cellular telephone applications are established. Also included are: battery pack electrical and mechanical construction, packaging technologies, pack and cell level charge and discharge controls, and overall system considerations

IEC 60086-5:2016 specifies tests and requirements for primary batteries with aqueous electrolyte to ensure their safe operation under intended use and reasonably foreseeable misuse. This fourth edition cancels and replaces the third edition published in 2011. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition:
 - The definition of explosion was changed to suitable sentence in order to harmonize in IEC 60086 series;

IEC 61056-1:2012 specifies the general requirements, functional characteristics and methods of test for all general purpose lead-acid cells and batteries of the valve-regulated type:
 - for either cyclic or float charge application;
 - in portable equipment, for instance, incorporated in tools, toys, or in static emergency, or uninterruptible power supply and general power supplies.