Recherche de CNR

Recherche dans le texte

Pertinence

Composante du système

Type de technologie SE

Référence	Sommaire
IEC 60622:2002	Secondary cells and batteries containing alkaline or other non-acid electrolytes - Sealed nickel-cadmium prismatic rechargeable single cells The standard specifies marking, tests and requirements for sealed nickel cadmium prismatic secondary single cells.
Norme CEI 60622:2002	Piles et batteries secondaires contenant des électrolytes alcalins ou autres non acides - Piles individuelles rechargeables prismatiques nickel-cadmium scellées La norme spécifie le marquage, les tests et les exigences pour les piles individuelles prismatiques scellées au nickel-cadmium.
Data Sheet 5-31	Cables and bus bars This data sheet covers electrical protection and fire protection for cables and bus bars and discusses aluminum conductors, describing methods of connecting, splicing and terminating to prevent excessive heating that could result in arcing and fire.
EN 50272-2:2001	Safety requirements for secondary batteries and battery installations - Part 2: Stationary batteries The standard applies to a 1500 VDC limit, protection against electricity, gas emission and electrolyte. It is limited to Lead-Acid and nickel technologies in applications for telecom, PV, uninterruptable power supply (UPS), emergency lighting, power station, stationary engine…
CWA 50611:2013	Flow batteries - Guidance on the specification, installation and operation The CWA provides guidance on the specification, installation and operation of flow batteries. It facilitates the pre-commercial phase when flow batteries need to be compared with other flow batteries or other electrical storage devices. It provides guidance to conformity…
ATIS-0600330.2018	Valve-Regulated Lead-Acid Batteries Used in the Telecommunications Environment Covers VRLA batteries, used as a reserve energy source that supports DC-powered telecommunications load equipment. Defines the proper operational use, storage conditions and test criteria initial and lifetime for VRLA cells (modules). Intended to be used to establish initial…
UN - 38.3	Recommendations on the Transport of Dangerous Goods - Manual of Test and Criteria - Lithium Metal and Lithium Ion Batteries The document presents the procedures to be followed for the classification of lithium metal and lithium ion cells and batteries (see UN Nos. 3090, 3091, 3480 and 3481, and the applicable special provisions of Chapter 3.3 of the Model Regulations). 38.3.2 Scope 38.3.2.1 All…
IEC 62281:2012	Safety of primary and secondary lithium cells and batteries during transport Specifies test methods and requirements for primary and secondary (rechargeable) lithium cells and batteries to ensure their safety during transport other than for recycling or disposal. Requirements specified in this standard do not apply in those cases where special…
Norme CEI 62281:2012	Sécurité des piles et batteries au lithium primaires et secondaires pendant le transport Spécifie les méthodes d'essai et les exigences pour les piles et batteries au lithium primaires et secondaires (rechargeables) afin d'assurer leur sécurité pendant le transport autre que pour le recyclage ou l'élimination. Les exigences spécifiées dans la présente norme ne s'…
IEC 61850-7-420	Communication networks and systems for power utility automation – Part 7-420: Basic communication structure – Distributed energy resources logical nodes IEC 61850-7-420:2009(E) defines IEC 61850 information models to be used in the exchange of information with distributed energy resources (DER), which comprise dispersed generation devices and dispersed storage devices, including reciprocating engines, fuel cells,…