Minimum Design Loads for Buildings and Other Structures, ASCE/SEI 7-10, is a complete revision of ASCE Standard 7-05. ASCE 7-10 offers a complete update and reorganization of the wind load provisions, expanding them from one chapter into six to make them more understandable and easier to follow.
This publication provides information on the physical and chemical properties of hydrogen and proper handling and use. It is intended to provide background information for personnel involved in the manufacture, distribution, and use of hydrogen. Additional technical information can be obtained from hydrogen gas manufacturers.
This publication presents design guidelines for hydrogen vent systems used in gaseous and liquid hydrogen systems at user sites and provides recommendations for safe operation of these vents. It begins at the discharge port of safety devices and other components that control the release of hydrogen and ends at the point where hydrogen concentration in the atmosphere is below the lower flammable limits.
This standard describes the specifications and general principles recommended for piping systems for gaseous (Type I) or liquid (Type II) hydrogen. The standard addresses both low and high pressure hydrogen piping systems onsite from the point where hydrogen enters the distribution piping (the battery limits of the hydrogen storage system) to the point of use. For the purposes of this standard, high pressure is defined as gaseous hydrogen at service pressures equal to or greater than 3000 psig (20 680 kPa).
Applies to protection equipment with coded bit serial data transmission for exchanging information with control systems. Defines a companion standard that enables interoperability between protection equipment and devices of a control system in a substation.
This publication is of high relevance for Smart Grid.
