The document outlines the fundamental conditions necessary for the creation of each hazard. It includes identification and characterization of the possible hazards inherent in the application, use, and abuse of Nickel Cadmium cells and batteries. It also includes examples for appliance design which minimizes these hazards. Additionally it presents some typical but non-exhaustive examples of misuse that may precipitate or actions which mitigate the hazard.
Applicable to substation automation systems: defines communication between intelligent electronic devices in substation and system requirements; provides overview of standard series; refers to text and figures from other parts of IEC 61850 series.
Specifies test methods and requirements for primary and secondary (rechargeable) lithium cells and batteries to ensure their safety during transport other than for recycling or disposal. Requirements specified in this standard do not apply in those cases where special provisions given in the relevant regulations, listed in 7.3, provide exemptions. This second edition cancels and replaces the first edition, published in 2004, and constitutes a technical revision.
The standard specifies marking, tests and requirements for sealed nickel cadmium prismatic secondary single cells.
The standard specifies marking, designation, dimensions, tests and requirements for vented Nickel Cadmium prismatic secondary single cells.
This part of IEC 60896 is applicable to Lead-Acid cells and batteries which are designed for service in fixed locations and which are permanently connected to the load and to the DC power supply. Part 11 of the standard is applicable to vented types only. The object of this standard is to specify general requirements and main characteristics with corresponding test methods associated with all types and construction modes of Lead-Acid stationary batteries, excluding valve-regulated types.
Applies to all stationary Lead-Acid cells and monobloc batteries of the valve regulated type for float charge applications (i.e., permanently connected to a load and to a DC power supply), in a static location and incorporated into stationary equipment or installed in battery rooms for use in telecom, UPS, utility switching, emergency power or similar applications. The objective is to specify test methods for all types and construction of valve regulated stationary Lead-Acid cells and monobloc batteries used in standby power applications.
Applies to all stationary Lead-Acid cells and monobloc batteries of valve regulated type for float charge applications, (i.e., permanently connected to load and DC power supply), in a static location and incorporated into stationary equipment or installed in battery rooms for use in telecom, UPS, utility switching, emergency power or similar applications.
