Installation

This data sheet covers electrical protection and fire protection for cables and bus bars and discusses aluminum conductors, describing methods of connecting, splicing and terminating to prevent excessive heating that could result in arcing and fire.

This part of the IEC 62485 applies to stationary secondary batteries and battery installations with a maximum voltage of DC 1 500 V (nominal) and describes the principal measures for protections against hazards generated from electricity, gas emission, and electrolyte.

The standard provides requirements on safety aspects associated with the erection, use, inspection, maintenance and disposal of cells and batteries for stationary applications and motive (other than on-road vehicle). Under development moving toward the committee draft voting stage. Includes safety requirements for lithium-ion cells for stationary and off-road motive applications and some battery requirements (evaluation of battery and battery management system [BMS] combination). Not a system standard, as it covers only battery and BMS interaction.

The standard provides electrical and mechanical requirements for liquid-immersed distribution and power transformers, and autotransformers and regulating transformers; single- and polyphase, with voltages of 601 V or higher in the highest voltage winding, are set forth. It is basis for the establishment of performance, and limited electrical and mechanical interchangeability requirements of equipment are described, and for assistance in the proper selection of such equipment.

The recommended practice document provides recommended design practices and procedures for storage, location, mounting, ventilation, instrumentation, preassembly, assembly, and charging of VLA batteries. Required safety practices are also included. This document is applicable to full-float stationary applications where a battery charger normally maintains the battery fully charged and provides DC loads.

The document provides a 3-level system of VRLA String Safety and Performance Criteria based on Telcordia generic requirements documents. The VRLA string criteria levels are defined as follows: ? Level 1, Safety and Minimal Operability – minimum acceptable level of compliance needed to preclude hazards and degradation of the network facility and hazards to personnel, and needed to ensure battery operability at the installation time in controlled environments.

1.1 This standard covers molded-case circuit breakers, circuit-breaker and ground-fault circuit interrupters, fused circuit breakers and accessory high-fault protectors. These circuit breakers are specifically intended to provide service entrance, feeder and branch circuit protection in accordance with the National Installation Codes in Annex B, Ref. 1. This standard covers instantaneous-trip circuit breakers (circuit interrupters) specifically intended as part of a combination motor controller in accordance with the National Installation Codes in Annex B, Ref. 1.

1.1.1 The scope includes, but is not limited to, the following: (1) Inspection of permanent and temporary buildings, processes, equipment, systems, and other fire and related life safety situations (2) Investigation of fires, explosions, hazardous materials incidents, and other related emergency incidents (3) Review of construction plans, drawings, and specifications for life safety systems, fire protection systems, access, water supplies, processes, hazardous materials, and other fire and life safety issues (4) Fire and life safety education of fire brigades, employees, responsible parties