Safety

1.1.1 The scope includes, but is not limited to, the following: (1) Inspection of permanent and temporary buildings, processes, equipment, systems, and other fire and related life safety situations (2) Investigation of fires, explosions, hazardous materials incidents, and other related emergency incidents (3) Review of construction plans, drawings, and specifications for life safety systems, fire protection systems, access, water supplies, processes, hazardous materials, and other fire and life safety issues (4) Fire and life safety education of fire brigades, employees, responsible parties

A.1.1 This standard provides a range of sprinkler system approaches, design development alternatives, and component options that are all acceptable. Building owners and their designated representatives are advised to carefully evaluate proposed selections for appropriateness and preference. 1.1.1 This standard shall provide the minimum requirements for the design and installation of automatic fire sprinkler systems and exposure protection sprinkler systems covered within this standard.

1.1.1 This recommended practice applies to preventive maintenance for electrical, electronic, and communication systems and equipment and is not intended to duplicate or supersede instructions that manufacturers normally provide. Systems and equipment covered are typical of those installed in industrial plants, institutional and commercial buildings, and large multifamily residential complexes. 1.1.2 Consumer appliances and equipment intended primarily for use in the home are not included.

A.1.1 The following is a suggested procedure for determining the Code requirements for a building or structure: (1) Determine the occupancy classification by referring to the occupancy definitions in Chapter 6 and the occupancy Chapters 12 through 42. (See 6.1.14 for buildings withmore than one use.) (2) Determine if the building or structure is new or existing. (See the definitions in Chapter 3.) (3) Determine the occupant load. (See 7.3.1.) (4) Determine the hazard of contents. (See Section 6.2.) (5) Refer to the applicable occupancy chapter of the Code, Chapters 12 through 42.

This standard establishes the minimum job performance requirements necessary for fire service and other emergency response personnel who perform technical rescue operations.

A.1.1 The Code does not address features that solely affect economic loss to private property. 1.1.1 General. The Code addresses those construction, protection, and occupancy features necessary to minimize danger to life and property. 1.1.2 Code Title. The provisions of this document shall constitute and be known as NFPA 5000, Building Construction and Safety Code, hereinafter referred to as “this Code” or “the Code.”

Wiring methods. The provisions of this section do not apply to conductors that are an integral part of factory-assembled equipment.

This Standard specifies the requirements for grid protection devices intended to be used in inverter energy systems, with ratings up to 10 kVA for single-phase units, or up to 30 kVA for three-phase units, and for the injection of electric power through an electrical installation to the electricity distribution network. NOTES: 1 Although this Standard does not apply to larger systems, similar principles can be used for the grid protection of such systems. 2 These devices do not replace devices used for protection and/or isolation as required in AS/NZS 3000.

This Standard establishes voltage standards for AC Systems in Canada to provide a guide: (a) To national committees on utilization and control equipment or devices for establishing standard ratings of such equipment or devices on a basis coordinated with standard systems; (b) To system designers so that new systems will be designed to accommodate standard ratings of equipment and devices; (c) To system operators and to electrical energy users for determining the need for corrective measures, with respect to existing systems, to accommodate current designs of equipment and devices; and (d) T