Safety

Applies to all stationary Lead-Acid cells and monobloc batteries of the valve regulated type for float charge applications (i.e., permanently connected to a load and to a DC power supply), in a static location and incorporated into stationary equipment or installed in battery rooms for use in telecom, UPS, utility switching, emergency power or similar applications. The objective is to specify test methods for all types and construction of valve regulated stationary Lead-Acid cells and monobloc batteries used in standby power applications.

Applies to all stationary Lead-Acid cells and monobloc batteries of valve regulated type for float charge applications, (i.e., permanently connected to load and DC power supply), in a static location and incorporated into stationary equipment or installed in battery rooms for use in telecom, UPS, utility switching, emergency power or similar applications.

Specifies marking, designation, dimensions, tests and performance requirements for portable sealed Nickel Cadmium small prismatic, cylindrical and button rechargeable single cells, suitable for use in any orientation.

Specifies marking, designation, dimensions, tests and performance requirements for portable sealed nickel-metal hydride, small prismatic, cylindrical and button rechargeable single cells, suitable for use in any orientation. This third edition cancels and replaces the second edition published in 2003 of which it constitutes a technical revision.

This standard and standard 62133-2 below are in development and are categorized in: Aerospace electric equipment and systems, Electrical and electronic equipment. These standards address safety of the respective battery chemistries for portable applications.

This part of the IEC 62485 applies to stationary secondary batteries and battery installations with a maximum voltage of DC 1 500 V (nominal) and describes the principal measures for protections against hazards generated from electricity, gas emission, and electrolyte.

The standard provides requirements on safety aspects associated with the erection, use, inspection, maintenance and disposal of cells and batteries for stationary applications and motive (other than on-road vehicle). Under development moving toward the committee draft voting stage. Includes safety requirements for lithium-ion cells for stationary and off-road motive applications and some battery requirements (evaluation of battery and battery management system [BMS] combination). Not a system standard, as it covers only battery and BMS interaction.

This technical report is in development is categorized in: Acid secondary, Alkaline secondary, Cells & batteries.

The recommended practice document provides recommended design practices and procedures for storage, location, mounting, ventilation, instrumentation, preassembly, assembly, and charging of VLA batteries. Required safety practices are also included. This document is applicable to full-float stationary applications where a battery charger normally maintains the battery fully charged and provides DC loads.