Switch Gear or Circuit Breakers

1.1 These requirements cover inverters, converters, charge controllers, and interconnection system equipment (ISE) intended for use in stand-alone (not grid-connected) or utility-interactive (grid-connected) power systems. 1.2 For utility-interactive equipment, these requirements are intended to supplement and be used in conjunction with the Standard for Interconnecting Distributed Resources With Electric Power Systems, IEEE 1547, and the Standard for Conformance Test Procedures for Equipment Interconnecting Distributed Resources with Electric Power Systems, IEEE 1547.1.

1.1 This Standard specifies the electrical requirements for safe interconnection of inverter-based micro-distributed resource (micro-DR) systems to low-voltage systems connected to distribution systems. The output of these systems is limited to 600 V (nominal) or less (single or three phase).
1.2 Intentional islanding conditions and interconnection to secondary networks are not covered in this Standard. Note: Inverter types and operating modes are provided in Annex F.

Intended Use
The objective of Standards issued as part of the Canadian Electrical Code, Part II, is to give consideration to the prevention of injury to persons and damage to property through proper design, good construction, and high quality of work. These safety Standards are intended to provide requirements for the design and construction of electrical equipment, primarily to address fire and electrical shock hazards and for use throughout Canada in conformity with the rules of the Canadian Electrical Code, Part I.

Description: Considered in this guide are the components of both the ac and dc systems and the provided guidelines and recommendations for designing the appropriate systems for the substation under consideration. This guide includes the low-voltage auxiliary systems from the source(s) to the distribution point(s). Reliability requirements and load characteristics are discussed and distribution methods are recommended.

Scope

1.1.1
This Model Code provides marking and test/construction requirements for the field evaluation of electrical equipment by an inspection body, where certification of that equipment is impracticable or otherwise unavailable.

1.1.2
Field-evaluated equipment found to be in conformity with the requirements of this Model Code is considered to be acceptable to the AHJ.

1.1.3

1 Scope
This standard specifies the re-use of electrical and electronic products and components and parts evaluation, evaluation of recycled materials, recycling Enterprises Evaluation
Claim.
This standard applies to electrical and electronic products for waste reuse and recycling processes are involved in the business and product systems
Evaluation.
2 Normative references
The following documents contain provisions which, through reference in this standard and become the standard terms. For dated references, subsequent