Pertinent

The standard specifies marking, tests and requirements for sealed nickel cadmium prismatic secondary single cells.

The standard specifies marking, designation, dimensions, tests and requirements for vented Nickel Cadmium prismatic secondary single cells.

This part of IEC 60896 is applicable to Lead-Acid cells and batteries which are designed for service in fixed locations and which are permanently connected to the load and to the DC power supply. Part 11 of the standard is applicable to vented types only. The object of this standard is to specify general requirements and main characteristics with corresponding test methods associated with all types and construction modes of Lead-Acid stationary batteries, excluding valve-regulated types.

Applies to all stationary Lead-Acid cells and monobloc batteries of the valve regulated type for float charge applications (i.e., permanently connected to a load and to a DC power supply), in a static location and incorporated into stationary equipment or installed in battery rooms for use in telecom, UPS, utility switching, emergency power or similar applications. The objective is to specify test methods for all types and construction of valve regulated stationary Lead-Acid cells and monobloc batteries used in standby power applications.

Applies to all stationary Lead-Acid cells and monobloc batteries of valve regulated type for float charge applications, (i.e., permanently connected to load and DC power supply), in a static location and incorporated into stationary equipment or installed in battery rooms for use in telecom, UPS, utility switching, emergency power or similar applications.

This international standard provides general information about secondary batteries used in PVES and the typical methods of test used for the verification of battery performance. This standard does not include specific information relating to battery sizing, method of charge or PVES design. NOTE: This standard is applicable to Lead-Acid and Nickel Cadmium cells and batteries. This standard will be amended to include other electrochemical systems when they become available.

The standard specifies marking, designation, dimensions, tests and requirements for vented Nickel Cadmium prismatic secondary single cells where special provisions have been made in order to have partial or, under very specific conditions, full gas recombination.

This part of the IEC 62485 applies to stationary secondary batteries and battery installations with a maximum voltage of DC 1 500 V (nominal) and describes the principal measures for protections against hazards generated from electricity, gas emission, and electrolyte.

The standard provides requirements on safety aspects associated with the erection, use, inspection, maintenance and disposal of cells and batteries for stationary applications and motive (other than on-road vehicle). Under development moving toward the committee draft voting stage. Includes safety requirements for lithium-ion cells for stationary and off-road motive applications and some battery requirements (evaluation of battery and battery management system [BMS] combination). Not a system standard, as it covers only battery and BMS interaction.

The standard specifies marking, designation, dimensions, tests and requirements for large format lithium-ion secondary single cells and batteries used in Industrial Applications including Stationary applications.